Ninebot ESX Error Code A0: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
For the [[Ninebot G30|Max G30]]/[[Ninebot SNSC 2.0|SNSC 2.0]]+, see [[Ninebot Max Error Code A0]]. | For the [[Ninebot G30|Max G30]]/[[Ninebot SNSC 2.0|SNSC 2.0]]+, see [[Ninebot Max Error Code A0]]. | ||
{{Ninebot ESX Error Code SEO|10}} | {{Ninebot ESX Error Code SEO|10}} | ||
Error "'''A0'''" is not an error. | |||
==Cause== | ==Cause== | ||
Latest revision as of 02:21, 10 December 2024
For the Max G30/SNSC 2.0+, see Ninebot Max Error Code A0.
If your Segway Ninebot ESX(ES1, ES2, ES3, or ES4) or Segway SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Error Code Index.
Next Error Code: Ninebot ESX Error Code 11
Error "A0" is not an error.
Cause
If your scooter displays "A0" and isn't charging anymore it's because your scooter is fully charged.
The "A" is the equivalent of "10" in hexadecimal, so you have 10 0 or 100% charged.
You likely installed firmware on your scooter with "show battery percentage while idle" enabled.
Fix
There is nothing you need to do as this isn't an issue.
It just means your scooter is fully charged.
If it bothers you you can flash stock firmware to the BLE and DRV/ESC to remove this functionality.