Ninebot ESX Error Code 27: Difference between revisions

From Joey's Wiki
Jump to navigation Jump to search
 
Line 19: Line 19:
===Temporary===
===Temporary===


To fix error 27, an easy temporary way is to simply press throttle and brake as soon as the vehicle is powered on.  
To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps.


This also acts as a sort of "lock" mechanism as failure to do this immediately after power-on results in a scooter that will continue beeping until it is turned off, though it is still able to be ridden.
This also acts as a sort of "lock" mechanism as failure to do this immediately after power-on results in a scooter that will continue beeping until it is turned off, though it is still able to be ridden.
Line 25: Line 25:
===Permanent===
===Permanent===


Change the ESC serial number twice using Ninebot IAP, Scooterhacking Utility, or some other application capable of changing the serial number or the "region".  
Change the serial number twice using a newer dAuth-supported serial change method.
 
Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this.
 
If that doesn't work, flashing a CFW using [https://esx.cfw.sh esx.cfw.sh] with error suppression 1 or more enabled will also solve the problem.


[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]]
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]]

Latest revision as of 01:15, 14 July 2024

Error 27 on a Ninebot ESX.
"Control Board Password Error, Please replace the Control Board"

Ninebot Error code 27 is the same on both the Ninebot ESX/SNSC 1.0 and the Ninebot Max/SNSC 2.0.

If your Segway Ninebot ESX(ES1, ES2, ES3, or ES4) or Segway SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Ninebot ESX Error Code 26 - Next Error Code: Ninebot ESX Error Code 28

Cause

This error occurs when ESC's are not properly STLinked or an incomplete firmware dump is used.

This error code is the same for the Ninebot Max G30 series scooters.

For the Max G30, visit Ninebot Max Error Code 27.

Fix

Temporary

To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps.

This also acts as a sort of "lock" mechanism as failure to do this immediately after power-on results in a scooter that will continue beeping until it is turned off, though it is still able to be ridden.

Permanent

Change the serial number twice using a newer dAuth-supported serial change method.

Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this.

If that doesn't work, flashing a CFW using esx.cfw.sh with error suppression 1 or more enabled will also solve the problem.

Retrieved from "https://joeybabcock.me/wiki/index.php?title=Ninebot_ESX_Error_Code_27&oldid=3041"