Ninebot Max Error Code 10: Difference between revisions

← Older edit

Ninebot Max Error Code 10 (view source)

Revision as of 17:22, 23 October 2024

778 bytes removed , 23 October 2024

no edit summary

Joeybab3

Administrators, Swags, Bureaucrats, Administrators

3,838

edits

@@ Line 1: / Line 1: @@
 [[File:NinebotMaxError10.png|thumb|center|200px|Error 10 on a Ninebot Max, the error displays the same message on both the SNSC 1.0 and the SNSC 2.0]]
- "Communication between Dashboard and Control Board is Abnormal, Please check the related connections"
+{{Ninebot Max Error Code 10 Summary}}
-Ninebot Error code 10 is the same on both the Ninebot ESX/SNSC 1.0 and the Ninebot Max/SNSC 2.0.
+This page documents Error 10 for the [[Ninebot G30P|Ninebot G30]], [[Ninebot G30P|G30P]], [[Ninebot G30D|G30D]], [[Ninebot Max G2|G2]], [[Ninebot Max G2D|G2D]], [[Ninebot Max G2E|G2E]] as well as the rental models [[Ninebot SNSC 2.0|SNSC 2.0]], and [[Ninebot SNSC 2.1|SNSC 2.1]].
-Error 10 is caused by the Dashboard being unable to communicate with the ESC.
+For the ESX/SNSC 1.0+, see [[Ninebot ESX Error Code 10]].
-This page documents Error 10 for the Ninebot G30, G30P, G30D as well as the rental models SNSC 2.0, and SNSC 2.1.
+{{Ninebot Max Error Code SEO|10}}
-For the ESX/SNSC 1.0+, see [[Ninebot ESX Error Code 10]].
 ==Cause==
-Error 10 is indicative of a dashboard issue. In some cases, the dashboard cannot communicate because the cable that is used to connect it was meant for an IoT unit on a rental scooter.
+{{Ninebot Max Error Code 10 Cause}}
-In other cases, the dashboard may have come unplugged or some part of the ESC may have failed causing the dashboard and ESC to not be able to communicate.
-Finally, a failed firmware update or CFW flash can also cause error 10 to show.
 ==Fix==
-Depending on what caused the issue, you have a few things to try.
+{{Ninebot Max Error Code 10 Solution}}
-First, try unplugging the dashboard and then plugging it back in.
-This may cause it to begin working again, or it may resume flashing error 10 as soon as its plugged back in.
-Flashing retail/stock firmware can sometimes alleviate the issue.
-If the vehicle cannot be connected to then you will need to STLink the ESC.
 [[Category: Scooters]][[Category: Ninebot]]