Administrators, Swags, Bureaucrats, Administrators
3,830
edits
STLink Ninebot Max G30 Gen 1 ESC: Difference between revisions
STLink Ninebot Max G30 Gen 1 ESC (view source)
Revision as of 22:56, 30 August 2024
, 30 August 2024no edit summary
No edit summary |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced | In the case of a bricked ESC/Controller/Control Board, STLinking can sometimes save the controller from needing to be replaced. | ||
{{ STLink Materials List }} | {{ STLink Materials List }} | ||
| Line 5: | Line 5: | ||
For the Ninebot ESX Series/[[Ninebot SNSC 1.0|SNSC 1.0]], use the guide at: [[STLink Ninebot ESX ESC]]. | For the Ninebot ESX Series/[[Ninebot SNSC 1.0|SNSC 1.0]], use the guide at: [[STLink Ninebot ESX ESC]]. | ||
This guide is for the Global G30 Gen 1 ESC with 1 | This guide is for the Global G30 Gen 1 ESC with 1 capacitor. It is the board revision v1.0. | ||
==Identify Which ESC Generation You Have== | ==Identify Which ESC Generation You Have== | ||
| Line 19: | Line 19: | ||
</ul></div> | </ul></div> | ||
Click the image above to | Click the image above to see the guide corresponding to your model. | ||
==Gen 1== | ==Gen 1== | ||
| Line 37: | Line 37: | ||
Carefully unplug each of the connectors. | Carefully unplug each of the connectors. | ||
You may need to scrape more rubber potting compound away from some of the connectors | You may need to scrape more rubber potting compound away from some of the connectors to unplug them. | ||
====Accessing The Pins==== | ====Accessing The Pins==== | ||
| Line 57: | Line 57: | ||
[[File:NinebotMaxESCSTLinkPinout.jpg|center|thumb|400px|Use either of the GND or VCC locations.]] | [[File:NinebotMaxESCSTLinkPinout.jpg|center|thumb|400px|Use either of the GND or VCC locations.]] | ||
If you | If you will attempt to use the BMS connector (and really you should do this anyway) make sure to unplug the battery before unplugging the dashboard and then press the power button a few times to drain the large capacitor onboard. | ||
*Open STM32 ST-Link utility and connect to the ESC using the plug at the top | *Open STM32 ST-Link utility and connect to the ESC using the plug at the top | ||
| Line 74: | Line 74: | ||
Remove the STLink and plug back in the ESC and use [[ScooterHacking Utility]] to check that your version number is now 1.2.6. | Remove the STLink and plug back in the ESC and use [[ScooterHacking Utility]] to check that your version number is now 1.2.6. | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: STLink]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: STLink]] | ||