Administrators, Swags, Bureaucrats, Administrators
3,838
edits
Ninebot Max Error Code 27: Difference between revisions
→Fix
No edit summary |
(→Fix) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 11: | Line 11: | ||
It can also be caused by using an old serial change method. | It can also be caused by using an old serial change method. | ||
This error is the same across the Ninebot SNSC 1.0, SNSC 1.1, ES1, ES2, ES3, ES4, Ninebot G30/Max, G30P, G30D, G30E, and any other Ninebot G30 series scooter. | This error is the same across the [[Ninebot SNSC 1.0]], [[Ninebot SNSC 1.1|SNSC 1.1]],[[Ninebot ES1|ES1]], [[Ninebot ES2|ES2]], [[Ninebot ES3|ES3]], [[Ninebot ES4|ES4]], Ninebot G30/Max, G30P, G30D, G30E, and any other Ninebot G30 series scooter. | ||
For ESX, visit [[Ninebot ESX Error Code 27]]. | |||
==Fix== | ==Fix== | ||
===Temporary=== | |||
To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps. | To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps. | ||
This also acts as a sort of "lock" mechanism as failure to do this immediately after power-on results in a scooter that will continue beeping until it is turned off, though it is still able to be ridden. | |||
===Permanent=== | |||
Change the serial number twice using a newer dAuth-supported serial change method. | |||
Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this. | Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this. | ||
If that doesn't, flashing a CFW using [https://max.cfw.sh max.cfw.sh] with error suppression 1 or more enabled will also solve the problem. | If that doesn't work, flashing a CFW using [https://max.cfw.sh max.cfw.sh] with error suppression 1 or more enabled will also solve the problem. | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | ||