Administrators, Swags, Bureaucrats, Administrators
3,838
edits
Ninebot Max G30 ESC Generations: Difference between revisions
no edit summary
(→Gen 1) |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
Rather than using the well-known STM32 chip most of the previous ESCs were based on, it used an AT32 chip. | Rather than using the well-known STM32 chip most of the previous ESCs were based on, it used an AT32 chip. | ||
This chip is only compatible with [[SHFW]] and | This chip is only compatible with [[SHFW]], and incompatible with conventional STM32-based CFW. | ||
Below are the differences between the Gen 1 ESC and the Gen 2 ESC. | Below are the differences between the Gen 1 ESC and the Gen 2 ESC. | ||
For motor generations, check out [[Ninebot Max Motor Generations]]. | For motor generations, check out [[Ninebot Max G30 Motor Generations]]. | ||
==Gen 1== | ==Gen 1== | ||
| Line 23: | Line 23: | ||
The G30D gen 1 also has 2 different board layouts, marked '''AA01''' and '''AB02''' on the back. | The G30D gen 1 also has 2 different board layouts, marked '''AA01''' and '''AB02''' on the back. | ||
[[File:NinebotMaxGen1G30DESC.jpg|thumb|center|400px|The G30D ESC has 3 capacitors on board rather than the usual 1 on the regular G30 ESC.]] | |||
==Gen 2== | ==Gen 2== | ||