STLink Ninebot Max G30 Gen 2 ESC: Difference between revisions
Jump to navigation
Jump to search
(Created page with "In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced in some instances. {{ STLink Materials List }} For the Ninebot ESX Series/SNSC 1.0, use the guide at: STLink Ninebot ESX ESC. ==Identify Which ESC Generation You Have== Check out the difference between the Ninebot Max ESC Generations and use the steps below depending on which one you have. <div><ul> <li style="display: inl...") |
|||
Line 26: | Line 26: | ||
Using an M4 Allen/Hex wrench or bit, remove the two screws holding the ESC in place. | Using an M4 Allen/Hex wrench or bit, remove the two screws holding the ESC in place. | ||
[[File: NinebotMaxESCLocations.jpg|thumb|center|400px| | [[File: NinebotMaxESCLocations.jpg|thumb|center|400px|This is a gen 1 esc but the gen 2 will be in the same place.]] | ||
Carefully unplug each of the connectors. | Carefully unplug each of the connectors. |