Administrators, Swags, Bureaucrats, Administrators
2,932
edits
(Created page with "In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced in some instances. {{ STLink Materials List }} For the Ninebot ESX Series/SNSC 1.0, use the guide at: STLink Ninebot ESX ESC. ==Identify Which ESC Generation You Have== Check out the difference between the Ninebot Max ESC Generations and use the steps below depending on which one you have. <div><ul> <li style="display: inl...") |
|||
Line 8: | Line 8: | ||
Check out the difference between the [[Ninebot Max ESC Generations]] and use the steps below depending on which one you have. | Check out the difference between the [[Ninebot Max ESC Generations]] and use the steps below depending on which one you have. | ||
There are 3 different board layouts. | |||
<div><ul> | <div><ul> | ||
<li style="display: inline-block;">[[File:NinebotMaxGen1ESC.jpg|thumb|center|400px|A Gen 1 ESC has bullet connectors and a silver metallic housing. Newer units may have writing as shown in this image.]]</li> | <li style="display: inline-block;">[[File:NinebotMaxGen1ESC.jpg|link=STLink Ninebot Max Gen 1 ESC|thumb|center|400px|A Gen 1 ESC has bullet connectors and a silver metallic housing. Newer units may have writing as shown in this image.]]</li> | ||
<li style="display: inline-block;">[[File: | <li style="display: inline-block;">[[File:NinebotMaxGen1G30DESC.jpg|link=STLink Ninebot Max Gen 1 G30D ESC|thumb|center|400px|A Gen 1 ESC has bullet connectors and a silver metallic housing. The G30D has 3 capacitors and a different location for the debug pins.]]</li> | ||
<li style="display: inline-block;">[[File:NinebotMaxGen2ESC.jpg|link=STLink Ninebot Max Gen 2 ESC|thumb|center|400px|This guide is meant for this model. These versions are based on the AT32 MCU rather than the STM32.]]</li> | |||
</ul></div> | </ul></div> | ||
Click the image above to go to the guide that corresponds to your model. | |||
==Gen 1== | ==Gen 1== |