Administrators, Swags, Bureaucrats, Administrators
2,822
edits
STLink Ninebot ESX ESC: Difference between revisions
→Accessing the Debug Pins
| Line 3: | Line 3: | ||
==Accessing the Debug Pins== | ==Accessing the Debug Pins== | ||
=== | ===Removing the Pole=== | ||
Remove the 4x Security Torx T25 screws or Hex Screws that hold the handlebar in place on the pole. | Remove the 4x Security Torx T25 screws or Hex Screws that hold the handlebar in place on the pole. | ||
| Line 12: | Line 12: | ||
[[File: NinebotEsxPoleScrews.jpg|thumb|center|400px|The pole screws in place.]] | [[File: NinebotEsxPoleScrews.jpg|thumb|center|400px|The pole screws in place.]] | ||
===Accessing the ESC=== | |||
Next comes arguably the most annoying part of the disassembly, removing the waterproofing grommets. | |||
On the top and the bottom is two grommets that are twisted in place. | |||
Press down hard with a large flathead screwdriver and twist counter-clockwise to remove. | |||
===Dissassembling the ESC=== | ===Dissassembling the ESC=== | ||