Wyse 5060 RAM Upgrade: Difference between revisions
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
==Dissassembly== | ==Dissassembly== | ||
To start, 3 screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | To start, 3 longer screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | ||
[[File:DellWyse5060FrontPanelScrews.jpg|thumb|center|400px|The 3 screws to remove.]] | [[File:DellWyse5060FrontPanelScrews.jpg|thumb|center|400px|The 3 screws to remove.]] | ||
Next slide the front cover off. | Next slide the front cover off. All screws past this point will be the same going forward. | ||
[[File:DellWyse5060FrontPanelRemoval.jpg|thumb|center|400px|Push down lightly and then slide the front cover off.]] | [[File:DellWyse5060FrontPanelRemoval.jpg|thumb|center|400px|Push down lightly and then slide the front cover off.]] | ||
| Line 13: | Line 13: | ||
Underneath the front panel are 5 screws holding on a structural/protective cover. Remove these and slide the cover in the direction of the arrow etched on the board. | Underneath the front panel are 5 screws holding on a structural/protective cover. Remove these and slide the cover in the direction of the arrow etched on the board. | ||
[[File: | [[File:DellWyse5060ProtectivePanelScrews.jpg|thumb|center|400px|The 5 screws to remove the protective panel.]] | ||
Once the panel is removed, you can unplug the attached speaker to fully remove it or set the panel aside. | |||
Two screws hold a heat shield on top of the two ram slots. | |||
[[File:DellWyse5060HeatShield.jpg|thumb|center|400px|The 2 screws hold the heat shield in place.]] | |||
Once the heat shield is removed, the ram should be visible. To access it more easily, remove the front IO ports. 3 Phillips screws hold the ports in place. | |||
[[File:DellWyse5060IOPortScrews.jpg|thumb|center|400px|The 3 screws hold the io ports in place.]] | |||
[[Category: Homelab]] | [[Category: Homelab]] | ||
Revision as of 04:07, 1 December 2023
This page shows how to upgrade the ram on the Dell Wyse 5060/N07D.
Dissassembly
To start, 3 longer screws hold the front cover in place. Use a small Phillips head screwdriver to remove them.
Next slide the front cover off. All screws past this point will be the same going forward.
Underneath the front panel are 5 screws holding on a structural/protective cover. Remove these and slide the cover in the direction of the arrow etched on the board.
Once the panel is removed, you can unplug the attached speaker to fully remove it or set the panel aside.
Two screws hold a heat shield on top of the two ram slots.
Once the heat shield is removed, the ram should be visible. To access it more easily, remove the front IO ports. 3 Phillips screws hold the ports in place.
