Administrators, Swags, Bureaucrats, Administrators
2,822
edits
No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
==Dissassembly== | ==Dissassembly== | ||
To start, 3 screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | To start, 3 longer screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | ||
[[File:DellWyse5060FrontPanelScrews.jpg|thumb|center|400px|The 3 screws to remove.]] | [[File:DellWyse5060FrontPanelScrews.jpg|thumb|center|400px|The 3 screws to remove.]] | ||
Next slide the front cover off. | Next slide the front cover off. All screws past this point will be the same going forward. | ||
[[File:DellWyse5060FrontPanelRemoval.jpg|thumb|center|400px|Push down lightly and then slide the front cover off.]] | [[File:DellWyse5060FrontPanelRemoval.jpg|thumb|center|400px|Push down lightly and then slide the front cover off.]] | ||
Line 13: | Line 13: | ||
Underneath the front panel are 5 screws holding on a structural/protective cover. Remove these and slide the cover in the direction of the arrow etched on the board. | Underneath the front panel are 5 screws holding on a structural/protective cover. Remove these and slide the cover in the direction of the arrow etched on the board. | ||
[[File: | [[File:DellWyse5060ProtectivePanelScrews.jpg|thumb|center|400px|The 5 screws to remove the protective panel.]] | ||
Once the panel is removed, you can unplug the attached speaker to fully remove it or set the panel aside. | |||
Two screws hold a heat shield on top of the two ram slots. | |||
[[File:DellWyse5060HeatShield.jpg|thumb|center|400px|The 2 screws hold the heat shield in place.]] | |||
Once the heat shield is removed, the ram should be visible. To access it more easily, remove the front IO ports. 3 Phillips screws hold the ports in place. | |||
[[File:DellWyse5060IOPortScrews.jpg|thumb|center|400px|The 3 screws hold the io ports in place.]] | |||
[[Category: Homelab]] | [[Category: Homelab]] |