Ninebot Max Error Code 11

This page documents Error 11 for the Ninebot Max G30, G30P, G30D as well as the rental models SNSC 2.0, and SNSC 2.1.

Error 11 on a Ninebot Max.

"Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"

For the ESX/SNSC 1.0+, see Ninebot ESX Error Code 11.

If your Ninebot Max is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Ninebot Max Error Code 10 - Next Error Code: Ninebot Max Error Code 12

Cause

As of yet I have not experienced this error code so I'm not entirely sure what causes it.

Fix

A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure.