Administrators, Swags, Bureaucrats, Administrators
2,822
edits
(Created page with "thumb|center|200px|Error 14 on a Ninebot ESX. "Throttle Hall is abnormal, please check the Throttle Switch, Dashboard & related Connections"...") |
No edit summary |
||
(2 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
"Throttle Hall is abnormal, please check the Throttle Switch, Dashboard & related Connections" | "Throttle Hall is abnormal, please check the Throttle Switch, Dashboard & related Connections" | ||
{{Ninebot ESX Error Code SEO|14}} | |||
==Cause== | ==Cause== | ||
It occurs when the hall sensor in the throttle receives an incorrect reading upon startup. | |||
This can be due to demagnetization of the neodymium magnets, dislodging of the magnets, or damage to the housing of the throttle assembly causing the lever to not seat properly. | |||
==Fix== | ==Fix== | ||
===Temporary=== | |||
In some cases, the error can be resolved by manually adjusting or pressing the throttle lever until the error disappears before riding. | |||
===Permanent=== | |||
Magnets may be dislodged from the throttle assembly and can be re-inserted into the proper slots by taking apart the throttle assembly. | |||
It is necessary to ensure that the polarity of the magnets is correct upon re-insertion. | |||
In some cases, this does not fix the issue or is not the problem, to begin with. | |||
In this case, the easiest solution is to replace the entire throttle assembly although it is possible that new magnets would also solve the issue. | |||
If the above doesn't solve error 14, you may need to try following the steps at [[Replace Ninebot ESX Throttle Hall Sensor]]. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] |