Ninebot Max Error Code 11

This page documents Error 11 for the Ninebot Max G30, G30P, and G30D, as well as the rental models SNSC 2.0 and SNSC 2.1.

Error 11 on a Ninebot Max.

"Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"

For the ESX/SNSC 1.0+, see Ninebot ESX Error Code 11.

Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.

If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.

Previous Error Code: Ninebot Max Error Code 10 - Next Error Code: Ninebot Max Error Code 12

Cause

I have not experienced this error code yet, so I'm not entirely sure what causes it.

Fix

Depending on what caused the issue, you have a few things to try.

First, try unplugging the dashboard and then plugging it back in.

This may cause it to begin working again, or it may resume flashing error 10 as soon as it's plugged back in.

Flashing retail/stock firmware can sometimes alleviate the issue.

If the vehicle cannot be connected to then you will need to STLink the ESC or BLE.