Segway Power Station Cube Error Code E13

"AC output short-circuit protection"

If your Segway Power Station Cube is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Power Station Cube Error Code Index.

Previous Error Code: Segway Power Station Cube Error Code E12 - Next Error Code: Segway Power Station Cube Error Code E14

Cause

Error 13 means there's likely a short circuit in your AC output connections or one of the devices connected to the AC outlets.

Fix

Disconnect the loads. Turn off the AC output after 5 seconds and try again later.

To fix error E13, try the following steps:

• Disconnect all the AC devices.
• Check your wiring and the devices themselves for any signs of damage or short circuits.
• Once the source of the short is fixed, turn off the AC output, wait for 5 seconds, and try again.