Administrators, Swags, Bureaucrats, Administrators
3,838
edits
Wyse 5060 RAM Upgrade: Difference between revisions
no edit summary
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
This page shows how to upgrade the | This page shows how to upgrade the RAM on the Dell Wyse 5060/N07D. | ||
== | ==Procedure== | ||
To start, 3 longer screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | To start, 3 longer screws hold the front cover in place. Use a small Phillips head screwdriver to remove them. | ||
| Line 23: | Line 23: | ||
Once the heat shield is removed, the ram should be visible. To access it more easily, remove the front IO ports. 3 Phillips screws hold the ports in place. | Once the heat shield is removed, the ram should be visible. To access it more easily, remove the front IO ports. 3 Phillips screws hold the ports in place. | ||
[[File:DellWyse5060IOPortScrews.jpg|thumb|center|400px|The 3 screws hold the | [[File:DellWyse5060IOPortScrews.jpg|thumb|center|400px|The 3 screws hold the IO ports in place.]] | ||
To get the bottom ram stick in, bend just the plastic front port cover out a little then push down on the ram stick until it clicks into place. This should not require much force. | |||
[[File:DellWyse5060IOPortCover.jpg|thumb|center|400px|The IO port can be moved out of the way to allow the bottom ram stick to be inserted.]] | |||
From here reassemble the device and test to make sure both sticks appear. | |||
[[Category: Homelab]] | [[Category: Homelab]] | ||