Ninebot Max Error Code 11: Difference between revisions
Jump to navigation
Jump to search
(→Cause) |
(→Fix) |
||
| Line 14: | Line 14: | ||
==Fix== | ==Fix== | ||
A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | ||
Revision as of 00:09, 12 January 2022
"Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"
This page documents Error 11 for the Ninebot Max G30, G30P, G30D as well as the rental models SNSC 2.0, and SNSC 2.1.
For the ESX/SNSC 1.0+, see Ninebot ESX Error Code 11.
Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.
If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.
Previous Error Code: Ninebot Max Error Code 10 - Next Error Code: Ninebot Max Error Code 12
Cause
As of yet I have not experienced this error code so I'm not entirely sure what causes it.
Fix
A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure.