Ninebot Max Error Code 11: Difference between revisions
No edit summary |
No edit summary |
||
| (12 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File: | [[File:NinebotMaxError11.png|thumb|center|200px|Error 11 on a Ninebot Max.]] | ||
{{Ninebot Max Error Code 11 Summary}} | |||
This page documents Error 11 for the Ninebot Max G30, G30P, and G30D, as well as the rental models SNSC 2.0 and SNSC 2.1. | |||
For the ESX/SNSC 1.0+, see [[Ninebot ESX Error Code 11]]. | |||
{{Ninebot Max Error Code SEO|11}} | |||
==Cause== | ==Cause== | ||
{{Ninebot Max Error Code 11 Cause}} | |||
==Fix== | ==Fix== | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: | {{Ninebot Max Error Code 11 Solution}} | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: G30]][[Category: Error Code]] | |||
Latest revision as of 17:24, 23 October 2024
This page documents Error 11 for the Ninebot Max G30, G30P, and G30D, as well as the rental models SNSC 2.0 and SNSC 2.1.
"Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"
For the ESX/SNSC 1.0+, see Ninebot ESX Error Code 11.
Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.
If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.
Previous Error Code: Ninebot Max Error Code 10 - Next Error Code: Ninebot Max Error Code 12
Cause
I have not experienced this error code yet, so I'm not entirely sure what causes it.
Fix
A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure.