Ninebot Max Error Code 11: Difference between revisions

Revision as of 17:23, 23 October 2024

"Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"

This page documents Error 11 for the Ninebot Max G30, G30P, and G30D, as well as the rental models SNSC 2.0 and SNSC 2.1.

For the ESX/SNSC 1.0+, see Ninebot ESX Error Code 11.

Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.

If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.

I have not experienced this error code yet, so I'm not entirely sure what causes it.

Depending on what caused the issue, you have a few things to try.

First, try unplugging the dashboard and then plugging it back in.

This may cause it to begin working again, or it may resume flashing error 10 as soon as it's plugged back in.

Flashing retail/stock firmware can sometimes alleviate the issue.

If the vehicle cannot be connected to then you will need to STLink the ESC or BLE.

@@ Line 3: / Line 3: @@
   "Wheel Hub Motor A Phase Current sampling is Abnormal, please check the main Control Board"
-This page documents Error 11 for the Ninebot Max G30, G30P, G30D as well as the rental models SNSC 2.0, and SNSC 2.1.
+This page documents Error 11 for the Ninebot Max G30, G30P, and G30D, as well as the rental models SNSC 2.0 and SNSC 2.1.
 For the ESX/SNSC 1.0+, see [[Ninebot ESX Error Code 11]].
@@ Line 11: / Line 11: @@
 ==Cause==
-As of yet, I have not experienced this error code so I'm not entirely sure what causes it.
+I have not experienced this error code yet, so I'm not entirely sure what causes it.
 ==Fix==
-A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure.
+{{Ninebot Max Error Code 10 Solution}}
 [[Category: Scooters]][[Category: Ninebot]][[Category: G30]][[Category: Error Code]]