Segway Power Station Cube Error Code E10: Difference between revisions
Jump to navigation
Jump to search
(Created page with " "Car output overload or short-circuit" {{Segway Power Station Cube Error Code SEO|10}} ==Cause== This error is likely caused by the 12v dc car-style output port drawing more than 10A. ==Fix== Disconnect the loads. Turn off the DC output after 5 seconds and try again later Make sure the device connected to the car port is not drawing more than 10A and there are no frayed wires or shorts. Category: Segway Power Station CubeCategory: Error Code") |
(No difference)
|
Latest revision as of 00:45, 24 February 2024
"Car output overload or short-circuit"
If your Segway Power Station Cube is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Power Station Cube Error Code Index.
Previous Error Code: Segway Power Station Cube Error Code E09 - Next Error Code: Segway Power Station Cube Error Code E11
Cause
This error is likely caused by the 12v dc car-style output port drawing more than 10A.
Fix
Disconnect the loads. Turn off the DC output after 5 seconds and try again later
Make sure the device connected to the car port is not drawing more than 10A and there are no frayed wires or shorts.