Template:Ninebot ESX Front Motor Disassembly - Front Panels

On either side of the motor, two plastic panels cover the screws.

Use a small flathead screwdriver to peel the panels back and loosen the clips carefully.

Carefully pry on both sides of the panel with a small flat head screwdriver.

Once the clips are removed, there are four small button-head M2.5/2.5mm hex/Allen screws holding the motor cover in place.

The 4 screws.

After these screws are removed, you can slide away the bolt guard that they were holding down to access the bolts.

The panel removed allowing access to the bolt.