Ninebot Max Error Code 27: Difference between revisions

← Older edit

Ninebot Max Error Code 27 (view source)

Revision as of 01:14, 14 July 2024

676 bytes added , 14 July 2024

→‎Fix

Joeybab3

Administrators, Swags, Bureaucrats, Administrators

3,838

edits

@@ Line 1: / Line 1: @@
 [[File:NinebotMaxError27.png|thumb|center|200px|Error 27 on a Ninebot Max.]]
-  "Control Board Password Error, Please replace the Control Board"
+  "Master Control Board Password Error, Please replace the Control Board"
+{{Ninebot Max Error Code SEO|27}}
 ==Cause==
@@ Line 8: / Line 10: @@
 It can also be caused by using an old serial change method.
+This error is the same across the [[Ninebot SNSC 1.0]], [[Ninebot SNSC 1.1|SNSC 1.1]],[[Ninebot ES1|ES1]], [[Ninebot ES2|ES2]], [[Ninebot ES3|ES3]], [[Ninebot ES4|ES4]], Ninebot G30/Max, G30P, G30D, G30E, and any other Ninebot G30 series scooter.
+For ESX, visit [[Ninebot ESX Error Code 27]].
 ==Fix==
-To temporarily fix, hold down the brake and throttle on boot up and release once it beeps.
+===Temporary===
+To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps.
+This also acts as a sort of "lock" mechanism as failure to do this immediately after power-on results in a scooter that will continue beeping until it is turned off, though it is still able to be ridden.
+===Permanent===
+Change the serial number twice using a newer dAuth-supported serial change method.
-Changing the serial number twice using a newer dAuth supported serial change method.
+Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this.
-If that doesn't, flashing a CFW using [https://cfw.max.sh cfw.max.sh] with error suppression enabled will also solve the problem.
+If that doesn't work, flashing a CFW using [https://max.cfw.sh max.cfw.sh] with error suppression 1 or more enabled will also solve the problem.
 [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]]