Woof IoT Removal

From Joey's Wiki
Revision as of 18:30, 17 July 2022 by Joeybab3 (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This page documents how to remove the Woof IoT from M4M.

Remove the Bottom Panel

Remove the 18 black t-15 security Torx screws holding the bottom plate of the scooter in place.

It's possible, especially if there's a metal plate that there may be different screws.

File:NinebotMaxBottomPlateScrews.jpg
The 18 screws holding the bottom plate on.

Attach the Debug Cable

Remove just the IoT from the 3-port mini-board.

File:WoofIoTRemoved.jpg
The IoT removed leaving the ESC and Dashboard plugged in.

After that, plug the debug cable into the board.

Download Software

You will need two pieces of software:

Install both, you can safely ignore the warning for IAP.

Connect Ninebot IAP

Once the Drivers and IAP are installed, plug the USB end of the debug cable into the PC.

Open Ninebot IAP and select the "Serial" tab.

Switching from BLE to Serial.

After that hit connect and you should see several version numbers in the upper-righthand corner.

From there hit "Load from Repo".

Select "BLE".

Select the first option (1.1.0).

Press "Flash".

Once it finishes, hit "Load from Repo" one more time.

This time hit "BMS".

Select the first option (1.3.4).

Press "Flash".

Once it finishes, hit "Load from Repo" one last time.

Select "DRV".

Select the first option (1.2.6).

Press "Flash".

Once it finishes, plug the dashboard cable directly into the ESC, and remove the mini-board.