Woof IoT Removal

This page documents how to remove the Woof IoT from M4M.

Attach the Debug Cable

Remove just the IoT from the 3-port mini-board.

File:WoofIoTRemoved.jpg

The IoT removed leaving the ESC and Dashboard plugged in.

After that, plug the debug cable into the board.

Download Software

You will need two pieces of software:

• ScooterHacking's Ninebot IAP: https://iap.scooterhacking.org/
• Silicon Lab's CP2102 Drivers: https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers

Install both, you can safely ignore the warning for IAP.

Connect Ninebot IAP

Once the Drivers and IAP are installed, plug the USB end of the debug cable into the PC.

Open Ninebot IAP and select the "Serial" tab.

Switching from BLE to Serial.

After that hit connect and you should see several version numbers in the upper righthand corner.