Woof IoT Removal
This page documents how to remove the Woof IoT from M4M.
Remove the Bottom Panel
Attach the Debug Cable
Remove just the IoT from the 3-port mini-board.
After that, plug the debug cable into the board.
Download Software
You will need two pieces of software:
- ScooterHacking's Ninebot IAP: https://iap.scooterhacking.org/
- Silicon Lab's CP2102 Drivers: https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers
Install both, you can safely ignore the warning for IAP.
Connect Ninebot IAP
Once the Drivers and IAP are installed, plug the USB end of the debug cable into the PC.
Open Ninebot IAP and select the "Serial" tab.