Administrators, Swags, Bureaucrats, Administrators
2,822
edits
No edit summary |
|||
(5 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
==Remove the Bottom Panel== | ==Remove the Bottom Panel== | ||
Remove the 18 black t-15 security Torx screws holding the bottom plate of the scooter in place. | |||
It's possible, especially if there's a metal plate that there may be different screws. | |||
[[File:NinebotMaxBottomPlateScrews.jpg|center|thumb|400px|The 18 screws holding the bottom plate on.]] | |||
==Attach the Debug Cable== | ==Attach the Debug Cable== | ||
Remove just the IoT from the 3 port mini-board. | Remove just the IoT from the 3-port mini-board. | ||
[[File: | [[File: WoofIoTRemoved.jpg|thumb|center|400px|The IoT removed leaving the ESC and Dashboard plugged in.]] | ||
After that, plug the debug cable into the board. | After that, plug the debug cable into the board. | ||
Line 17: | Line 23: | ||
*ScooterHacking's Ninebot IAP: [https://iap.scooterhacking.org/ https://iap.scooterhacking.org/] | *ScooterHacking's Ninebot IAP: [https://iap.scooterhacking.org/ https://iap.scooterhacking.org/] | ||
*Silicon Lab's CP2102 Drivers: [https://www.silabs.com/documents/public/software/CP210x_Windows_Drivers.zip https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers] | *Silicon Lab's CP2102 Drivers: [https://www.silabs.com/documents/public/software/CP210x_Windows_Drivers.zip https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers] | ||
Install both, you can safely ignore the warning for IAP. | |||
==Connect Ninebot IAP== | ==Connect Ninebot IAP== | ||
Once the Drivers and IAP are installed, plug the USB end of the debug cable into the PC. | |||
Open Ninebot IAP and select the "Serial" tab. | |||
[[File: NinebotIAPSerialMode.png|thumb|center|400px|Switching from BLE to Serial.]] | |||
After that hit connect and you should see several version numbers in the upper-righthand corner. | |||
From there hit "Load from Repo". | |||
Select "BLE". | |||
Select the first option (1.1.0). | |||
Press "Flash". | |||
Once it finishes, hit "Load from Repo" one more time. | |||
This time hit "BMS". | |||
Select the first option (1.3.4). | |||
Press "Flash". | |||
Once it finishes, hit "Load from Repo" one last time. | |||
Select "DRV". | |||
Select the first option (1.2.6). | |||
Press "Flash". | |||
Once it finishes, plug the dashboard cable directly into the ESC, and remove the mini-board. | |||
[[Category: Scooters]][[Category: Ninebot Max]][[category: Woof IoT]] | [[Category: Scooters]][[Category: Ninebot Max]][[category: Woof IoT]] |