Template:Ninebot ESX Reassemble Internals

Start by placing the plastic battery-ESC clip into the battery.

The clip placed securely onto the battery.

Thread the dashboard cable through the power cable on the battery.

The dashboard cable threaded through the battery cable.

Plug in the 4-pin data line.

The data cable firmly plugged in.

Plug in the power cable.

The power cable plugged in.

Feed the loose dashboard cable until it is mostly tight.

Clip the ESC to the battery.

The esc clipped to the battery.

Press firmly to reinstall the dashboard cable into the channel, pulling the dashboard cable tight.

The dashboard cable installed in the battery channel.

Slide the battery and ESC into the pole.

The assembly should slide upward into the pole.

Align the charging port and insert the small screw.

The assembly should fit perfectly with the charging port lining up.

If using an external battery, use Loctite/thread lock on the 3 holes.

Blue loctite/threadlock insures that the battery is secure and helps prevent error 42.