Template:Ninebot ESX Reassemble Internals: Difference between revisions

← Older edit

Template:Ninebot ESX Reassemble Internals (view source)

Revision as of 01:39, 2 September 2023

1,460 bytes added , 2 September 2023

no edit summary

Joeybab3

Administrators, Swags, Bureaucrats, Administrators

2,822

edits

@@ Line 36: / Line 36: @@
 [[File:NinebotESXBracketPrep.jpg|thumb|center|400px|Blue loctite/threadlock insures that the battery is secure and helps prevent error 42.]]
+Take care reinstalling the 3 bracket screws as they strip very easily.
+[[File:NinebotESXExternalBatteryBracketScrews.jpg|thumb|center|400px|The 3 easily-strippable screws.]]
+If you do not have a bracket then you will have three screws holding the battery in place within the pole.
+[[File:NinebotESXInternalBatteryPoleScrews.jpg|thumb|center|400px|The 3 screws that hold the internal battery in place within the pole.]]
+You will also have a charging port cover to reinstall.
+Install the two screws and the cover.
+[[File:NinebotESXChargingPortCoverScrews.jpg|thumb|center|400px|The port cover removed.]]
+If you have an external battery, two screws hold the battery on the bracket.
+These are either security hex or regular hex.
+[[File:NinebotESXExternalBatteryScrews.jpg|thumb|center|400px|The two screws holding the external battery on the bracket.]]
+Plug in the dashboard cable to the dashboard in the handlebar.
+Test that the scooter still functions before continuing with assembly.
+Reinstall the 4x Security Torx T25 screws or Hex Screws that hold the handlebar in place on the pole.
+[[File: NinebotEsxHandlebarScrews.jpg|thumb|center|400px|The handlebar screws in place.]]
+Reinstall the 4x Security Torx T30 screws or Hex screws that hold the pole to the base.
+[[File: NinebotEsxFrontPoleScrews.jpg|thumb|center|400px|The front pole screws in place.]]
+[[File: NinebotEsxRearPoleScrews.jpg|thumb|center|400px|The rear pole screws in place.]]
 Check that the scooter is sturdy and nothing is loose.