Administrators, Swags, Bureaucrats, Administrators
2,822
edits
Template:Ninebot ESX Reassemble Internals: Difference between revisions
Template:Ninebot ESX Reassemble Internals (view source)
Revision as of 01:27, 2 September 2023
, 2 September 2023no edit summary
(Created page with "Start by placing the plastic battery-ESC clip into the battery. Thread the dashboard cable through the power cable on the battery and then plug in the data line, then the power cable and feed the loose dashboard cable through until tight. Press firmly to reinstall the dashboard cable into the channel. Clip the ESC to the battery.") |
No edit summary |
||
| Line 1: | Line 1: | ||
Start by placing the plastic battery-ESC clip into the battery. | Start by placing the plastic battery-ESC clip into the battery. | ||
[[File:NinebotESXBatteryESCClipInPlace.jpg|thumb|center|400px|The clip placed securely onto the battery.]] | |||
Thread the dashboard cable through the power cable on the battery. | |||
[[File:NinebotESXDashboardCableThreading.jpg|thumb|center|400px|The dashboard cable threaded through the battery cable.]] | |||
Plug in the 4-pin data line. | |||
[[File:NinebotESXDataCablePluggedIn.jpg|thumb|center|400px|The data cable firmly plugged in.]] | |||
Plug in the power cable. | |||
[[File:NinebotESXPowerCablePluggedIn.jpg|thumb|center|400px|The power cable plugged in.]] | |||
Feed the loose dashboard cable until it is mostly tight. | |||
Clip the ESC to the battery. | Clip the ESC to the battery. | ||
[[File:NinebotESXBatteryESCClipped.jpg|thumb|center|400px|The esc clipped to the battery.]] | |||
Press firmly to reinstall the dashboard cable into the channel, pulling the dashboard cable tight. | |||
[[File:NinebotESXDashboardCableInstalled.jpg|thumb|center|400px|The dashboard cable installed in the battery channel.]] | |||
Slide the battery and ESC into the pole. | |||
[[File:NinebotESXBatteryEscPole.jpg|thumb|center|400px|The assembly should slide upward into the pole.]] | |||
Align the charging port and insert the small screw. | |||
[[File:NinebotESXBatteryEscInPole.jpg|thumb|center|400px|The assembly should fit perfectly with the charging port lining up.]] | |||
If using an external battery, use Loctite/thread lock on the 3 holes. | |||
[[File:NinebotESXBracketPrep.jpg.jpg|thumb|center|400px|Blue loctite/threadlock insures that the battery is secure and helps prevent error 42.]] | |||