STLink Ninebot Max ESC: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
Line 18: | Line 18: | ||
===Accessing the ESC=== | ===Accessing the ESC=== | ||
Start by removing the 18 Security Torx T-15 screws on the bottom. | |||
[[File: NinebotMaxBottomScrewLocations.jpg|thumb|center|400px|The locations of the 18 screws.]] | |||
==Software== | ==Software== |
Revision as of 17:38, 30 September 2021
In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced in some instances.
For this process you will need:
- Windows computer
- STLink (Decent quality clones will work)
- Tools to disassemble the scooter and access the ESC
- Dupont male/female jumper cables
This process can be dangerous if done incorrectly so take caution when performing these steps and make sure you use a computer you are comfortable possibly destroying.
If you short a battery line you could end up blowing up your STLink, Computer, and more or even causing a fire.
Accessing the Debug Pins
Accessing the ESC
Start by removing the 18 Security Torx T-15 screws on the bottom.
Software
Download STM32 STLink Utility from the ST website.
Scroll down and click "Get Software" and enter your email to receive a download link.
Install it and open it.