STLink Ninebot Max ESC: Difference between revisions
Line 25: | Line 25: | ||
Using an M4 Allen/Hex wrench or bit, remove the two screws holding the ESC in place. | Using an M4 Allen/Hex wrench or bit, remove the two screws holding the ESC in place. | ||
[[File: | [[File: NinebotMaxESCLocations.jpg|thumb|center|400px|The ESC after being removed.]] | ||
==Software== | ==Software== |
Revision as of 17:43, 30 September 2021
In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced in some instances.
For this process you will need:
- Windows computer
- STLink (Decent quality clones will work)
- Tools to disassemble the scooter and access the ESC
- Dupont male/female jumper cables
This process can be dangerous if done incorrectly so take caution when performing these steps and make sure you use a computer you are comfortable possibly destroying.
If you short a battery line you could end up blowing up your STLink, Computer, and more or even causing a fire.
Accessing the Debug Pins
Accessing the ESC
Start by removing the 18 Security Torx T-15 screws on the bottom.
Using an M4 Allen/Hex wrench or bit, remove the two screws holding the ESC in place.
Software
Download STM32 STLink Utility from the ST website.
Scroll down and click "Get Software" and enter your email to receive a download link.
Install it and open it.