STLink Ninebot Max ESC: Difference between revisions

← Older edit

STLink Ninebot Max ESC (view source)

Revision as of 19:53, 17 September 2023

798 bytes added , 17 September 2023

no edit summary

Joeybab3

Administrators, Swags, Bureaucrats, Administrators

2,822

edits

@@ Line 1: / Line 1: @@
 In the case of a bricked ESC/Controller/Control Board, STLinking can save the controller from needing to be replaced in some instances.
-==Accessing the Debug Pins==
+{{ STLink Materials List }}
-===Accessing the ESC===
+For the Ninebot ESX Series/[[Ninebot SNSC 1.0|SNSC 1.0]], use the guide at: [[STLink Ninebot ESX ESC]].
-==Software==
+==Identify Which ESC Generation You Have==
-Download [https://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software-development-tools/stm32-programmers/stsw-link004.html#get-software STM32 STLink Utility] from the ST website.
+Check out the difference between the [[Ninebot Max ESC Generations]] and use the steps below depending on which one you have.
-Scroll down and click "Get Software" and enter your email to receive a download link.
+There are 3 different board layouts.
-Install it and open it.
+<div><ul>
+<li style="display: inline-block;">[[File:NinebotMaxGen1ESC.jpg|link=STLink Ninebot Max Gen 1 ESC|thumb|center|400px|A Gen 1 ESC has bullet connectors and a silver metallic housing. Newer units may have writing as shown in this image.]]</li>
+<li style="display: inline-block;">[[File:NinebotMaxGen1G30DESC.jpg|link=STLink Ninebot Max Gen 1 G30D ESC|thumb|center|400px|A Gen 1 ESC has bullet connectors and a silver metallic housing. The G30D has 3 capacitors and a different location for the debug pins.]]</li>
+<li style="display: inline-block;">[[File:NinebotMaxGen2ESC.jpg|link=STLink Ninebot Max Gen 2 ESC|thumb|center|400px|A Gen 2 ESC has screw terminals and a black plastic housing. These versions are based on the AT32 MCU rather than the STM32.]]</li>
+</ul></div>
-==Flashing==
+Click the image above to go to the guide that corresponds to your model.
-[[Category: Scooters]][[Category: Ninebot]][[Category: Max]]
+[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: STLink]]