Ninebot Max Error Code A0

Revision as of 18:49, 12 April 2022 by Joeybab3 (talk | contribs)

Error "A0" is not actually an error.

Error A0 on a Ninebot Max, the 'error' displays on both the SNSC 1.0 and the SNSC 2.0 when the battery is full.

This page documents Error A0 for the Ninebot G30, G30P, G30D as well as the rental models SNSC 2.0, and SNSC 2.1.

For the ESX/SNSC 1.0+, see Ninebot ESX Error Code A0.

If your Ninebot Max is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Next Error Code: Ninebot Max Error Code 11

Cause

If your scooter displays "A0" and isn't charging anymore it's because your scooter is fully charged.

The "A" is the equivalent of "10" in hexadecimal, so you have 10 0 or 100% charged.

You likely installed firmware on your scooter with "show battery percentage while idle" enabled.

This is on by default in SHFW.

Fix

There is nothing you need to do as this isn't an issue.

It just means your scooter is fully charged.

If it bothers you you can flash stock firmware to the BLE and DRV/ESC to remove this functionality.