Ninebot Max Error Code 27

From Joey's Wiki
Revision as of 19:25, 30 July 2021 by Joeybab3 (talk | contribs)
Jump to navigation Jump to search
Error 27 on a Ninebot Max.
"Control Board Password Error, Please replace the Control Board"

Cause

Error 27 occurs when rental vehicles are not properly STLinked or an incomplete firmware dump is used.

It can also be caused by using an old serial change method.

This error is the same across the Ninebot SNSC 1.0, SNSC 1.1, ES1, ES2, ES3, ES4, Ninebot G30/Max, G30P, G30D, G30E, and any other Ninebot G30 series scooter.

Fix

To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps.

Changing the serial number twice using a newer dAuth supported serial change method.

Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this.

If that doesn't, flashing a CFW using cfw.max.sh with error suppression 1 or more enabled will also solve the problem.