Administrators, Swags, Bureaucrats, Administrators
2,822
edits
(Created page with "thumb|center|200px|Error 27 on a Ninebot Max. "Control Board Password Error, Please replace the Control Board" ==Cause== ==Fix== Category...") |
No edit summary |
||
(7 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
[[File:NinebotMaxError27.png|thumb|center|200px|Error 27 on a Ninebot Max.]] | [[File:NinebotMaxError27.png|thumb|center|200px|Error 27 on a Ninebot Max.]] | ||
"Control Board Password Error, Please replace the Control Board" | "Master Control Board Password Error, Please replace the Control Board" | ||
{{Ninebot Max Error Code SEO|27}} | |||
==Cause== | ==Cause== | ||
Error 27 occurs when rental vehicles are not properly STLinked or an incomplete firmware dump is used. | |||
It can also be caused by using an old serial change method. | |||
This error is the same across the Ninebot SNSC 1.0, SNSC 1.1, ES1, ES2, ES3, ES4, Ninebot G30/Max, G30P, G30D, G30E, and any other Ninebot G30 series scooter. | |||
==Fix== | ==Fix== | ||
To temporarily fix error 27, hold down the brake and throttle on boot up and release once it beeps. | |||
Changing the serial number twice using a newer dAuth-supported serial change method. | |||
Ninebot IAP, Ninebot-Flasher, and a ScooterHacking Utility all support this. | |||
If that doesn't, flashing a CFW using [https://max.cfw.sh max.cfw.sh] with error suppression 1 or more enabled will also solve the problem. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] |