Administrators, Swags, Bureaucrats, Administrators
2,800
edits
(Created page with "thumb|center|200px|Error 24 on a Ninebot ESX. "System Voltage detection is abnormal, Please check the Control Board" ==Cause== This error is...") |
No edit summary |
||
(2 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
"System Voltage detection is abnormal, Please check the Control Board" | "System Voltage detection is abnormal, Please check the Control Board" | ||
{{Ninebot ESX Error Code SEO|24}} | |||
==Cause== | ==Cause== | ||
Line 15: | Line 17: | ||
==Fix== | ==Fix== | ||
If the abnormal voltage is intended (such as is the case when performing the aforementioned battery mod to 48v), flashing [[Custom Ninebot | If the abnormal voltage is intended (such as is the case when performing the aforementioned battery mod to 48v), flashing [[Custom Ninebot ESX/SNSC Firmware]] with an error suppression level of 2 (ignore battery mod warnings) should solve it. | ||
If the error is unexpected and the user has not performed any modifications, the battery may need to be run down and recharged. | If the error is unexpected and the user has not performed any modifications, the battery may need to be run down and recharged. | ||
Line 23: | Line 25: | ||
If the voltage runs down and the error goes away, keep using the scooter until it is near 25% and then charge it fully again. | If the voltage runs down and the error goes away, keep using the scooter until it is near 25% and then charge it fully again. | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] |