Ninebot ESX Error Code 18

Error 18 on a Ninebot ESX.

"Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections"

If your Ninebot ESX(ES1, ES2, ES3, or ES4) or SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Ninebot ESX Error Code 17 - Next Error Code: Ninebot ESX Error Code 19

Cause

Often times error 18 is caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned.

Occasionally this can also occur if the sensors themselves are burned.