Ninebot ESX Error Code 18: Difference between revisions

From Joey's Wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 14: Line 14:


Reseat the motor hall connector and restart the scooter.
Reseat the motor hall connector and restart the scooter.
Make sure the plug is firmly in place before reassembling.


If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out.
If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out.


[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]]
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]]

Revision as of 22:23, 16 February 2022

Error 18 on a Ninebot ESX.
"Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections"

If your Ninebot ESX(ES1, ES2, ES3, or ES4) or SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Ninebot ESX Error Code 17 - Next Error Code: Ninebot ESX Error Code 19

Cause

Often times error 18 is caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned.

Occasionally this can also occur if the sensors themselves are burned.

Fix

Reseat the motor hall connector and restart the scooter.

Make sure the plug is firmly in place before reassembling.

If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out.