Ninebot ESX Error Code 18: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
(→Cause) |
||
Line 6: | Line 6: | ||
==Cause== | ==Cause== | ||
Often times error 18 is caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned. | |||
Occasionally this can also occur if the sensors themselves are burned. | |||
==Fix== | ==Fix== | ||
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] |
Revision as of 22:22, 16 February 2022
"Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections"
If your Ninebot ESX(ES1, ES2, ES3, or ES4) or SNSC (1.0 or 1.1) is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Error Code Index.
Previous Error Code: Ninebot ESX Error Code 17 - Next Error Code: Ninebot ESX Error Code 19
Cause
Often times error 18 is caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned.
Occasionally this can also occur if the sensors themselves are burned.