Administrators, Swags, Bureaucrats, Administrators
2,822
edits
(Created page with "thumb|center|200px|Error 18 on a Ninebot ESX. "Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections"...") |
No edit summary |
||
(7 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
"Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections" | "Wheel Hub Motor Hall is abnormal, Please check the Motor, Control Board & related connections" | ||
{{Ninebot ESX Error Code SEO|18}} | |||
==Cause== | ==Cause== | ||
Often, on a Ninebot ES1, ES2, ES3, or ES4, '''Error 18''' is due to the controller failing to retrieve proper values from the hall sensors. | |||
This can be caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned. | |||
Occasionally this can also occur if the sensors themselves are burned or damaged. | |||
==Fix== | ==Fix== | ||
Reseat the motor hall connector and restart the scooter. | |||
Make sure the plug is firmly in place before reassembling. | |||
If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out. | |||
If no other steps work, you may need to follow the guide at: [[Replace Ninebot ESX Motor]]. | |||
Discussions about fixing the hall sensor issue that can cause this are also available on the [https://www.scooterhacking.org/forum/viewtopic.php?f=6&t=174 ScooterHacking Forum]. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] |