Administrators, Swags, Bureaucrats, Administrators
2,811
edits
No edit summary |
No edit summary |
||
Line 7: | Line 7: | ||
==Cause== | ==Cause== | ||
Often | Often error 18 is caused by the motor hall sensor cable (the 2 x 3 connector) coming loose or getting burned. | ||
Occasionally this can also occur if the sensors themselves are burned. | Occasionally this can also occur if the sensors themselves are burned. | ||
Line 19: | Line 19: | ||
If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out. | If reseating doesn't work then attempt to plug the motor into another controller and see if some part of the old controller is burned out. | ||
If no other steps | If no other steps work, you may need to follow the guide at: [[Replace Ninebot ESX Motor]]. | ||
Discussions about fixing the hall sensor issue that can cause this are also available on the [https://www.scooterhacking.org/forum/viewtopic.php?f=6&t=174 ScooterHacking Forum]. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: ESX]][[Category: Error Code]] |