Okai Error Code 18E
"The throttle not at the original position"
If your Okai-Electisan vehicle is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Error Code Index.
Previous Error Code: Okai Error Code 17E - Next Error Code: Okai Error Code 19E
Cause
Error code 18E indicates that the throttle sensor is not detecting the throttle in its initial position during the self-test. This could be due to:
- Short circuit: The throttle signal wire or the power wire might be shorted to ground or to each other, causing incorrect readings.
- Damaged throttle sensor: The throttle sensor itself might be faulty or out of calibration.
- Incorrect throttle position: The throttle might be physically stuck in a position other than its intended starting point.
Fix
- Turn the throttle to original position.
- Check if the connections are loose.