Okai Error Code 10E

"Brake failure - Check brake wires, adjust brake line."

If your Okai-Electisan vehicle is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Error Code Index.

Previous Error Code: Okai Error Code 09E - Next Error Code: Okai Error Code 11E

Cause

Error code 10E indicates a problem with the left brake lever control system. This could be due to:

Open circuit: The wire connecting the left brake lever to the ECU might be broken or disconnected.
Short circuit: The left brake signal wire or the power wire might be shorted to ground or to each other.
Damaged brake lever: The left brake lever itself might be faulty.

Check brake lever wiring: Inspect the wires connecting the left brake lever to the ECU for any signs of damage, breaks, or loose connections.
Check for shorts: Make sure the left brake signal wire and the power wire are not shorted to ground or to each other.
Replace brake lever: If the wiring is in good condition, the brake lever itself might be faulty and need replacement.