Ninebot Max Error Code 18: Difference between revisions

Latest revision as of 19:49, 1 June 2025

"Wheel Hub Motor Hall is abnormal , Please check the Motor, Control Board & related connections"

Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.

If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.

Error 18 is thrown when the scooter detects an abnormal reading from the hall sensors in the motor.

This can be due to an unplugged cable, or a blown sensor/resistor.

The best case scenario would be that the 5-pin motor cable has come unplugged or was severed somehow.

Check the cable and visually inspect that it is still plugged in firmly and is free from any fraying.

After that, a new motor may be needed, or the sensors may need to be repaired.

If your motor is vibrating loudly or the connectors have melted, you will likely need to replace the connectors or the motor: Ninebot Max G30 Melted Connectors/Loud Motor Vibration

@@ Line 13: / Line 13: @@
 ==Fix==
-The best case scenario would be that the 5 pin motor cable has come unplugged or was severed somehow.
+The best case scenario would be that the 5-pin motor cable has come unplugged or was severed somehow.
 Check the cable and visually inspect that it is still plugged in firmly and is free from any fraying.
-After that, a new motor may be needed or the sensors may need to be repaired.
+After that, a new motor may be needed, or the sensors may need to be repaired.
+If your motor is vibrating loudly or the connectors have melted, you will likely need to replace the connectors or the motor:
+[[Ninebot Max G30 Melted Connectors/Loud Motor Vibration]]
 [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]]