Administrators, Swags, Bureaucrats, Administrators
3,830
edits
Ninebot Max G30 Change Serial/Region: Difference between revisions
→Instructions
| Line 59: | Line 59: | ||
Select your device in the menu and press "Connect". | Select your device in the menu and press "Connect". | ||
It may ask you to press the power button to pair | It may ask you to press the power button to pair; in this case, short-press the button that you would normally use to power it on or toggle the headlight. | ||
[[File:NinebotIAPSuccessfulG30VersionRead.png|thumb|center|400px|A successful connection showing version numbers.]] | [[File:NinebotIAPSuccessfulG30VersionRead.png|thumb|center|400px|A successful connection showing version numbers.]] | ||
| Line 65: | Line 65: | ||
If it shows version numbers in the "Installed Firmware" box, you have successfully connected. | If it shows version numbers in the "Installed Firmware" box, you have successfully connected. | ||
From here head to the "Tools" menu under "Utilities". | From here, head to the "Tools" menu under "Utilities". | ||
Press "Read" in the "ESC Serial Number" panel. | Press "Read" in the "ESC Serial Number" panel. | ||
| Line 77: | Line 77: | ||
[[File:NinebotIAPChangingG30Serial.png|thumb|center|400px|Changing the serial prefix from a 'D' to a 'C'.]] | [[File:NinebotIAPChangingG30Serial.png|thumb|center|400px|Changing the serial prefix from a 'D' to a 'C'.]] | ||
Press | Press "OK", then you should hear your scooter beep twice in quick succession. | ||
To confirm it has successfully changed, press | To confirm it has successfully changed, press "Read" again, and you should see your new serial. | ||
[[File:NinebotIAPChangingG30SerialChanged.png|thumb|center|400px|A successful change.]] | [[File:NinebotIAPChangingG30SerialChanged.png|thumb|center|400px|A successful change.]] | ||