Template:Ninebot ESX Reassemble Internals: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
Line 36: | Line 36: | ||
[[File:NinebotESXBracketPrep.jpg|thumb|center|400px|Blue loctite/threadlock insures that the battery is secure and helps prevent error 42.]] | [[File:NinebotESXBracketPrep.jpg|thumb|center|400px|Blue loctite/threadlock insures that the battery is secure and helps prevent error 42.]] | ||
Check that the scooter is sturdy and nothing is loose. |
Revision as of 01:39, 2 September 2023
Start by placing the plastic battery-ESC clip into the battery.
Thread the dashboard cable through the power cable on the battery.
Plug in the 4-pin data line.
Plug in the power cable.
Feed the loose dashboard cable until it is mostly tight.
Clip the ESC to the battery.
Press firmly to reinstall the dashboard cable into the channel, pulling the dashboard cable tight.
Slide the battery and ESC into the pole.
Align the charging port and insert the small screw.
If using an external battery, use Loctite/thread lock on the 3 holes.
Check that the scooter is sturdy and nothing is loose.