Administrators, Swags, Bureaucrats, Administrators
2,932
edits
Line 46: | Line 46: | ||
==Flashing== | ==Flashing== | ||
Connect the STLink to the ESC according to the diagram below. | |||
The BMS port red and black wires can also be connected to provide power instead of using the BMS connector and ground point. | |||
[[File:NinebotMaxESCSTLinkPinout.jpg|center|thumb|400px]] | |||
*Open STM32 ST-Link utility and connect to the ESC using the plug at the top | |||
*Press Target->Connect from the top menu | |||
[[File:StLinkUtilityNinebotMax.png|thumb|center|400px|No error messages about "Unable to connect to target" should display.]] | |||
*Press "Open File" and open [[File:NinebotMAX FULLESC126.bin]]. | |||
[[File:StLinkUtilityNinebotMaxESCProgram.png|thumb|center|400px|At this point a red LED should light up on the board.]] | |||
*From the top menu, press Target->Program & verify or ctrl+p. | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]] |