Ninebot Max Error Code 13: Difference between revisions
(→Fix) |
(→Fix) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File:NinebotMaxError13.png|thumb|center|200px|Error 13 on a Ninebot Max.]] | [[File:NinebotMaxError13.png|thumb|center|200px|Error 13 on a Ninebot Max.]] | ||
{{Ninebot Max Error Code 13 Summary}} | |||
{{Ninebot Max Error Code SEO|13}} | {{Ninebot Max Error Code SEO|13}} | ||
| Line 7: | Line 7: | ||
==Cause== | ==Cause== | ||
{{Ninebot Max Error Code 13 Cause}} | |||
==Fix== | ==Fix== | ||
{{Ninebot Max Error Code 13 Solution}} | |||
[[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | [[Category: Scooters]][[Category: Ninebot]][[Category: Max]][[Category: Error Code]] | ||
Latest revision as of 17:34, 23 October 2024
Read below if your Ninebot Max G30 or G2 is beeping or has a red wrench icon and flashes this code.
"Wheel Hub Motor C Phase Current sampling is Abnormal, please check the main Control Board"
If you clicked the wrong error code, return to the Max G30 and G2 Error Code Index.
Previous Error Code: Ninebot Max Error Code 12 - Next Error Code: Ninebot Max Error Code 14
Cause
I have not experienced this error code yet, so I'm not entirely sure what causes it.
Fix
A new ESC should fix it but as mentioned, I haven't seen this error so I can't say for sure.
Check the phase wires (three large motor cables) for signs of damage.