Administrators, Swags, Bureaucrats, Administrators
3,830
edits
Template:Ninebot ESX Access Internals: Difference between revisions
Template:Ninebot ESX Access Internals (view source)
Revision as of 17:15, 27 November 2024
, 27 November 2024no edit summary
No edit summary Tag: Manual revert |
No edit summary |
||
| Line 43: | Line 43: | ||
Next comes arguably the most annoying part of the disassembly, removing the waterproofing grommets. | Next comes arguably the most annoying part of the disassembly, removing the waterproofing grommets. | ||
On the top and the bottom | On the top and the bottom are two grommets that are twisted in place. | ||
Press down hard with a large flathead screwdriver and twist counter-clockwise until the slots | Press down hard with a large flathead screwdriver and twist counter-clockwise until the slots align with the metal ridge within the pole. | ||
[[File:NinebotESXInternalRubberGrommets.jpg|thumb|center|400px|Keep the grommets attached if you can.]] | [[File:NinebotESXInternalRubberGrommets.jpg|thumb|center|400px|Keep the grommets attached if you can.]] | ||
| Line 51: | Line 51: | ||
[[File:NinebotESXInternalRubberGrommetsRemoved.jpg|thumb|center|400px|The parts of the grommet.]] | [[File:NinebotESXInternalRubberGrommetsRemoved.jpg|thumb|center|400px|The parts of the grommet.]] | ||
In some cases, pushing the rubber inner part through the plastic retainer ring will make it easier | In some cases, pushing the rubber inner part through the plastic retainer ring will make removing it easier. | ||
Attempt to keep the wires pushed through the rubber part. | Attempt to keep the wires pushed through the rubber part. | ||