Okai Error Code 10E: Difference between revisions
Jump to navigation
Jump to search
(Created page with " "Brake failure - Check brake wires, adjust brake line." {{Okai Error Code SEO|10}} ==Cause== Error code 10E indicates a problem with the left brake lever control system. This could be due to: * Open circuit: The wire connecting the left brake lever to the ECU might be broken or disconnected. * Short circuit: The left brake signal wire or the power wire might be shorted to ground or to each other. * Damaged brake lever: The left brake lever itself might be faulty. =...") |
(No difference)
|
Latest revision as of 00:10, 31 August 2024
"Brake failure - Check brake wires, adjust brake line."
If your Okai-Electisan vehicle is beeping or has a red wrench icon and flashes this code, read below.
If you clicked the wrong error code, go back to the Error Code Index.
Previous Error Code: Okai Error Code 09E - Next Error Code: Okai Error Code 11E
Cause
Error code 10E indicates a problem with the left brake lever control system. This could be due to:
- Open circuit: The wire connecting the left brake lever to the ECU might be broken or disconnected.
- Short circuit: The left brake signal wire or the power wire might be shorted to ground or to each other.
- Damaged brake lever: The left brake lever itself might be faulty.
Fix
- Check brake lever wiring: Inspect the wires connecting the left brake lever to the ECU for any signs of damage, breaks, or loose connections.
- Check for shorts: Make sure the left brake signal wire and the power wire are not shorted to ground or to each other.
- Replace brake lever: If the wiring is in good condition, the brake lever itself might be faulty and need replacement.